Installing Wire-Free Motion Sensors
Mounting your Cync Motion Sensor.
Screw Mount
Recommended tools:
Philips Screw Driver, Drill with 7/32 bit and a tape measure
- Before installing, remove plastic battery tab on the motion sensor. Also be sure to separate the magnet and bracket so you can secure the bracket to the wall.
- Identify where you want to mount your Wire-Free Motion Sensor (Try the sensor in various locations to determine the ideal spot for your application. Recommended placing between 66-78” from the floor.)
- Mark the location for hole to be drilled.
- Using a 7/32” bit, drill hole in wall for mounting screw, insert anchor.
- Secure bracket to the wall until flush and seat magnetic mount.
- Mount sensor at desired angle.
Free Standing
- Motion sensor can be placed vertically or horizontally with the use of included magnetic mount
- Identify where you want to place your wireless motion sensor. Any level shelf or surface is an ideal location for your sensor
- Install motion sensor and rotate to ideal angle
We recommend commissioning the device before installation. This allows the ability to test different placement options, check the sensor’s sensitivity, and adjust settings as needed before permanently mounting it.
Related Articles
Wire-Free Cync Motion Sensor - FAQs Number of Views Resetting a Wire-Free Cync Motion Sensor Number of Views Setting Up Wire-Free Cync Motion Sensors Number of Views Installing Wire-Free Cync Switches Number of Views Installing Cync Smart Panels Number of Views